• Bespoke manufactured
  • All pre Drilled and Counter Sunk, 
  • Buff Or Yellow Platform Blister Tiles
  • ​Load Bearing.
  • 30 Years life span
All panels will be made to order under factory controlled conditions to the following specification:
  • Independently Tested slip resistance to conform to the required figures for both wet & dry conditions.
  • Nominal thickness of 10 mm on site requirements
  • Panels will be supplied complete with:
  • Main panel – Black, approved for Rail use.
  • Tactile – Buff (RAL 1001), set 760mm back from the front edge.
  • Sight lines – White, 100mm x 100mm Bullnose.
  • Sight lines – yellow, 100mm sightline 1250mm from the edge.
  • Weight of each individual 1200mm x 2500mmGRP platform panel is approx. 40kg. This equates to approx

​Suredeck Plywood Platform Sheets
​The ideal solution to providing a DDA compliant floor to timber platforms and ramps.

  • Slip resistance complies with British Standards
  • Can be cut and worked on using normal woodworking tools
  • Available in a variety of colours
  • Available in a range of sheet sizes and thicknesses

​All panels will be made to order under factory controlled conditions to the following specification:
  • Independently Tested slip resistance to conform to the required figures for both wet & dry conditions.
  • Nominal thickness of 24 mm on site requirements

Panels will be supplied complete with:

​below sizes would need to be confirmed and altered to your requirements:
  • Main panel – Black, approved for Rail use.
  • Tactile – Buff (RAL 1001), set 760mm back from the front edge.
  • Sight lines – White, 100mm  sightline ​(this can be bullnosed or down turned with a 100mm riser in white)
  • Sight lines – yellow, 100mm  sightline 1250mm from the edge.